Tweet
When I started eac firstly it showed a window Configure accurate rip. But I don't remember what it said, because I wasn't paying attention to it. Now I want the program to ask me this again. I tried to uninstall it several times and even after new installation it doesn't ask me this anymore. How can I delete this settings in order that the program will ask me this again?
-
-
Re: Accurate rip configuration
If would have configured the drive offset, look on the options page to see the drive offset (it should be disabled so you cannot edit it), to be extra sure you can visit www.accuraterip.com and look on the drive offsets page to see if your offset matches the expected one. -
Re: Accurate rip configuration
But where to look if these offsets are right? Which drive offsets page? Because under EAC offset settings I can't see offset settings, because there are no numbers .
But is there any way to make accurate rip show this configure windows again?
I also uninstalled the eac and deleted eac and accurate rip maps under appdata-romaing...
Is this wrong?
Because even after this accurate windows doesn't wanna show up again.Comment
-
Re: Accurate rip configuration
HKEYCURRENTUSER >> Software >> Illustrate
remove this Illustrate key (folder)Comment
-
Re: Accurate rip configuration
Thnx. I did this. I also installed eac again and configure accurate window did show up.
But it said that I would need 3 key discs to configure it. But after second key disc it didn't ask me to put the third disc in it.
So the problem is that I needed only 2 key discs but not 3.
How can I see if accurate rip is configured properly (correctly)?Comment
-
Re: Accurate rip configuration
You only need 1 key disc if your drive is in the database and you have a match to it.Comment
Comment