Tweet
Hi all.
My 2nd and I hope last question. I have dbpoweramp now set up.
Accuraterip has calibrated my sample offset at +102 and is set.
I want to get a Plextor drive next, but am learning with my current CD Drive.
I have Manufacturer: MATSHITA
CD Drive: DVD-RAM UJ-850S
Firmware: 1.20
Serial: 70219UKMEMB88043067
Maximum Speed: 4234 KB/sec (x24)
Current Speed: 4234 KB/sec (x24)
Spin-down After: 32 seconds
Buffer Size: 2 MB
Accurate Stream: Yes
C2 Error Pointers: Yes
Reads ISRC: Yes
Reads UPC: Yes
•Overread Lead-In and Lead-Out: Unchecked in most cases.
Check "Overread Lead-In and Lead-Out" only if the test result says that your drive can overread from both the Lead-In and Lead-Out, or if it says Lead-Out and your offset correction is positive ,or if it says Lead-In and your offset correction is negative. Otherwise disable (uncheck) it.
How do i run a test or know if i need to check or leave this box (Lead-in / Lead -out) unchecked?
Regards
Craig
My 2nd and I hope last question. I have dbpoweramp now set up.
Accuraterip has calibrated my sample offset at +102 and is set.
I want to get a Plextor drive next, but am learning with my current CD Drive.
I have Manufacturer: MATSHITA
CD Drive: DVD-RAM UJ-850S
Firmware: 1.20
Serial: 70219UKMEMB88043067
Maximum Speed: 4234 KB/sec (x24)
Current Speed: 4234 KB/sec (x24)
Spin-down After: 32 seconds
Buffer Size: 2 MB
Accurate Stream: Yes
C2 Error Pointers: Yes
Reads ISRC: Yes
Reads UPC: Yes
•Overread Lead-In and Lead-Out: Unchecked in most cases.
Check "Overread Lead-In and Lead-Out" only if the test result says that your drive can overread from both the Lead-In and Lead-Out, or if it says Lead-Out and your offset correction is positive ,or if it says Lead-In and your offset correction is negative. Otherwise disable (uncheck) it.
How do i run a test or know if i need to check or leave this box (Lead-in / Lead -out) unchecked?
Regards
Craig
Comment