My setup works great and I've ripped 100s of CDs except for this issue. Here's what happens:


I'm on a new Windows 11 PC, followed these steps exactly, and also this guide. Haven't changed any settings except for setting "reject on metadata fail" to false (but the erroring discs in question do have metadata). Ripping mode is Burst (I tried Secure but it just hanged for 30 minutes on a damaged disk without anything happening).
Appreciate any ideas!
- Any time any disc is marked as "Ripping Error" (usually a damaged disc), it fails to load any more discs
- The Nimbie does not open the tray nor unload the damaged disc
- Batch Ripper then shows "Post-Load Waiting For CD" for a minute or so, then "No CD After Load". During this time, the drive doesn't open or close, nor does the Nimbie load or unload anything
- It repeats this until I manually end the batch or it hits the limit of number of failed loads
- AFTER the batch ends this way, Batch Ripper shows an error "Drive Different to Configured Drive" and I need to close and open Batch Ripper and then it will work normally again
- When it starts up, it unloads the damaged disc into the reject pile, then continues ripping normally
I'm on a new Windows 11 PC, followed these steps exactly, and also this guide. Haven't changed any settings except for setting "reject on metadata fail" to false (but the erroring discs in question do have metadata). Ripping mode is Burst (I tried Secure but it just hanged for 30 minutes on a damaged disk without anything happening).
Appreciate any ideas!
Comment