CDgrab.exe crash

[ErikM]

OK everything was fine... Now when ever I try and start R12.1 an error message comes up that CDgrab.exe has encountered a problem and R12.1 just shuts down! wtf is going on?? I have tried completly removing R12.1 ( registered copy) and reinstalling fresh still getting the same message and results. help!!!!

[LtData]

Re: CDgrab.exe crash

By remove do you mean uninstall, or do you mean you deleted the install directory and the registry data, as specified here: http://forum.dbpoweramp.com/showthread.php?t=6828

Also, does it matter if there is a CD in the drive when the CD Ripper crashes?

[ErikM]

Re: CDgrab.exe crash

I uninstalled from control panel. then I removed the illustrate folder from the programs file.. And yes it R12 will open ok untill I load a CD then the error message comes up and the R12 shuts down. Should I completly remove it using the outlined proceedure?

[ErikM]

Re: CDgrab.exe crash

I just uninstalled using the listed procedure and R12 is working again, except that the options for secure ripping are greyed out and I can only rip in burst mode?????

[ErikM]

Re: CDgrab.exe crash

I got it working.. reinstalled a registered copy. Only thing now is that R12 sez my drive doesn't support fua.. it did before.. strange.

[LtData]

Re: CDgrab.exe crash

Does r12 work fine now? Are you sure you drive doesn't support FUA and it wasn't a fluke before?

[ErikM]

Re: CDgrab.exe crash

Yup, I ripped a couple of cd's and it's working as before. Not sure if my drive supports fua or not. I seem to remember that it did before but maybe I'm wrong. Strange...