Here is my drive info from dBpoweramp:Manufacturer: ATAPI
CD Drive: DVD A DH20A4P
Firmware: 9P54
Serial: 2007/09/27 11:26
Maximum Speed: 8467 KB/sec (x47)
Current Speed: 8467 KB/sec (x47)
Spin-down After: 2 minutes
Buffer Size: 2 MB
Accurate Stream: Yes
C2 Error Pointers: Yes
Reads ISRC: Yes
Reads UPC: Yes
My question is:
According to Spoons secure ripping setup guide it says that if my drive supports C2 error pointers which it does that I should set the Ultra Secure setting to this Minimum Ultra Passes: 1 Maximum Ultra Passes: 2 End After Clean Passes: 1 and I was wondering if I should use this settings because I don't know how well the C2 Error Pointers are supported by my drive.
Is there a better setting?
Also, I don't know the size of my drive cache, so should I just keep it at 1024Kb?
CD Drive: DVD A DH20A4P
Firmware: 9P54
Serial: 2007/09/27 11:26
Maximum Speed: 8467 KB/sec (x47)
Current Speed: 8467 KB/sec (x47)
Spin-down After: 2 minutes
Buffer Size: 2 MB
Accurate Stream: Yes
C2 Error Pointers: Yes
Reads ISRC: Yes
Reads UPC: Yes
My question is:
According to Spoons secure ripping setup guide it says that if my drive supports C2 error pointers which it does that I should set the Ultra Secure setting to this Minimum Ultra Passes: 1 Maximum Ultra Passes: 2 End After Clean Passes: 1 and I was wondering if I should use this settings because I don't know how well the C2 Error Pointers are supported by my drive.
Is there a better setting?
Also, I don't know the size of my drive cache, so should I just keep it at 1024Kb?
Comment