How To ?-Convert Mp3

[blaiseit]

I followed these instructions from Audiogenerator.com where I downloaded your software trial.

" Once you install it, you'll be able to right-click on a .WAV file and select 'Convert' then you'll be able to select all the right options. Make sure you select them all correctly! You need to select, 24kbps, 22.05khz, and Mono. We also recommend that you select 'normalize' so your message will be at maximum volume without any distortion."


After the music converter window opened I did not see a selection for "24 kbps, 22.05khz, and Mono".



Thanks in advance.

[xoas]

Re: How To ?-Convert Mp3

After you have opened Music Converter andd you are selecting the music file(s) to be converted, try selecting Mp3(Lame), near the top for the files settings for your mp3 output file, on the line that reads "Target" select Constant Bit Rate and move the slider down until you get the reading of 24 kbs. Further down, on the line that reads "Encoding" click on the button that says Advanced. There you can set your frequency to 22 kHz and your chanels to "1 (mono)".

If the resulting conversion runs into problems, try running the same conversion with the Resample DSP (assuming the original Wave file is other than 22 kHz). If the source file is not mono, than you may need either or both the Channel Count and Channel Mapper DSPs.

Let us know if you have any problems.

Best wishes,
Bill