Simple Question about using R12

[richs]

Excuse my simple questions. I've started using Poweramp Reference version after using EAC for years. I'm trying to get my rips as accurate as possible (in EAC I used secure mode, so there was error correction.)

I can't see where I enable secure mode. Is this done automatically? My drive has been configured for accurate rip. But when I rip a cd I get either "not in accurate rip" or "accurate rip" by each track. I just ripped Bob Dylan's "Hard Rain," and on all tracks I got the "not in accurate rip" message. I suspect that a cd this common is in the database, so does this mean that my rip couldn't be confirmed as accurate? And if it's not confirmed as accurate (either because it doesn't match other rips, or the cd's not in the database) does secure mode kick in with some form of error correction, a la EAC?

Thanks in advance. I'm just trying to configure dbpoweramp to give me as accurate rips as possible.

Rich

[LtData]

Re: Simple Question about using R12

Click the options button and then select "Secure Mode" instead of "Burst Mode". Then click the settings button to see the options for secure mode. Most of the options are explained in the CD Ripper help file that is included in dMC.

When in secure mode, if AccurateRip does not match, it goes into Secure mode and, if enabled in the secure options, Ultra Secure mode. Again, how secure mode works is explained in the help files.

[richs]

Re: Simple Question about using R12

Thank you. I was clicking the drop down arrow on the right of the box, rather than the box itself. All is clear now.

Rich