When Converting to Mono Crashes

[ms22282]

I uses r12, and when I try to convert something to mono, the application crashes.
Error: Watchdog timeout, possible CoreConverter crash

CoreConverter.exe has encountered a problem and needs
to close. We are sorry for the inconvenience.
If you were in the middle of something, the information you were working on
might be lost. 43 Minutes Remaining
For more information about this error, click here.

CoreConverter.exe
Error signature
AppName: coreconverter.exe AppVer: 12.0.1.0 ModName: mp3 (lame).dll
ModVer: 12.0.1.0 Offset: 0006159b
To view technical information about the error report, click here.

[LtData]

Re: When Converting to Mono Crashes

Try using the Channel Count DSP and setting it to 1. DSPs are found here: http://forum.dbpoweramp.com/showthread.php?t=12210

[Wikkus]

Re: When Converting to Mono Crashes

Try using the Channel Count DSP and setting it to 1. DSPs are found here: http://forum.dbpoweramp.com/showthread.php?t=12210

No, I'm not the OP (but "Hi", anyway :D) , but I just installed RM12 and was getting the same prob as the OP... Was driving me nuts -- all I want to do is down-mix a chunk of MP3 for a ring-tone

So, searched for "crash", found this thread, saw the above response, grabbed the DSP pack, followed the advice as above and... Bingo! Works a treat!

Thanks guys... Will be registering very soon

Rik.