dBpowerAMP (dMC) don't get files to convert

[grafzahl]

this problem had been discussed in forum.dbpoweramp.com/showthread.php?t=5924 but a solution was not found.
I have installed dBpowerAMP (dMC) Release 11.5 with administrator rights under Windows-2000.

the problem:
i mark a wave-file (or any sound file) and then i start dBpowerAMP via context menu (convert to).
But dBpowerAMP shows "converting 0 Files", therefore there is nothing to convert and dBpowerAMP don't convert by starting the convert process. It doesen't matter which format the destination file has to be.
If i start dBpowerAMP (dMC) directly and browse for sound files it has the same effect.
In the case i start Windows in safe mode then dBpowerAMP (dMC) works fine.

I've tried several times to uninstall, reboot, remove anything from the dbpoweramp folder and remove dbpoweramp related registry entries but a new installation has the same effect described before.

[coblesan]

Re: dBpowerAMP (dMC) don't get files to convert

I saw a post one time about this problem and it turned out to be a problem with the path. Too many characters. However, this is weird since it works in "Safe" mode.

Hum!

[grafzahl]

Re: dBpowerAMP (dMC) don't get files to convert

Thank You coblesan for the hint!

The problem is solved by installing DMC on C:\
In my case i tried to install DMC on F:\
The path under the drive letter was exactly the same, so it can't be a problem with too many characters in the path.