Tweet
In the past I ripped to 3 different files, with one set up, but can't seem to figure out how to do it currently. Can someone please advise how to set it up. I used to rip to a file on my computer in MP3, a different file in WAV, and an archive file on an external hard drive in WAV. I am not sure if it was multiple encoders or how I did it but can't figure it out now. Did that capability get removed? Thanks for any advice about this.
-
-
Multi encoder is the way to go. Add encoders to your liking, but be aware, that you have to setup and configure each encoder individually (path, naming string etc. pp.).
Dat Ei -
Thanks but I don't see how to add more encoders. Could you please be more specific. I see the encoder tab and set up a profile. But how do zi set up a profike with multiple encoders. I did have it set up before on an older computer but can't seem to do it on this one. Is it possible its a software version I have? Thanks again, BillComment
-
Choose [multi encoder] as the encoder in the lower left section, then on the encoder tab where normally is the settings for the chosen encoder click the add button to add a new encoder into multi encoder.
no profiles are used.Comment
Comment