no result observed from DSP: Move Destination File on Error

[gearfreak]

Howdy,

Through many and varied attempts (tag and/or absolute paths etc.) I've been unable to observe any action resulting from application of the DSP: Move Destination File on Error.

Present details:

CD Ripper: Options> Secure Options > 'Mark track as Error if Insecure'
...is engaged, and tracks in question do show as 'Error' within the interface

++ Encoder: Multi-Encoder >
WAVE [DSP: Move Destination File on Error settings applied herein]
MP3 [No DSP applied]

+++ ...WAVE Encoder:
Output location: Dynamic
Folder: E:\0007_WAV
Dynamic: [artist]\[album]\[title]

++++ DSP: Move Destination File on Error settings:

Root Path: E:\0007_INSECURE_RIP\
Naming: error\[title]


Can anyone suggest the problem/further troubelshooting?

Thoughts:
-perhaps this DSP does not work with the multi-encoder (vs single encoder) ? (is next planned test)
-try a different output drive? (there've been no issues with the CD Ripper output creation on this drive so far)


thanks!

[Spoon]

Re: no result observed from DSP: Move Destination File on Error

No it cannot work with the multi encoder, you could try putting the DSP effect on the settings page for the codec within multi-encoder.

[gearfreak]

Re: no result observed from DSP: Move Destination File on Error

Thanks Spoon. I think that is where I have it defined there already.

Perhaps you can confirm, I have it at:

>Launch CD Ripper...
>> [[Multi Encoder] Encoder Settings] > Select [Wave]
>>> Settings...
>>>> [DSP Effects / Actions] : (Move Destination File...)

[gearfreak]

(resolved) multiencoder no result observed from DSP: Move Destination File on Error

Ahh, I got it, now.

I had had it defined within the wave encoder. This was the wrong place.
I added it instead as a DSP on the multiencoder itself. [i.e. of the vertical side tabs: DSP/Encoder/Meta)]

Success, thanks!