After not using it the past couple of months, I just booted up my Dell Windows 10 laptop that is connected to the Acronova Nimbie disc loader. I tried using Batch Ripper, but it now can't see the Nimbie.
CD Ripper shows D: [TEAC - DV - W5600S] but the Rip icon in the upper left-hand side is not active.
Batch Ripper shows select drive which to be inactive and says E: [TEAC - DV - W5600S] CD Drive No Longer Present
I can't redirect Bath Ripper to the D: drive where the Nimbie is located, and once again the Rip icon in the upper left is not active.
Device manager says the Nimbie is attached and operating fine.
Any thoughts on why I can't seem to direct Bath Ripper to the D: drive and connect to the Nimbie?
I have updated to the new dbPoweramp software and I have made sure the dbPoweramp suite of programs were selected in Windows Security settings under Manage Settings.
I'm pretty puzzled, having spent a couple of hours trying to get this to work again. Any suggestions would be appreciated.
Thanks.
Marc
CD Ripper shows D: [TEAC - DV - W5600S] but the Rip icon in the upper left-hand side is not active.
Batch Ripper shows select drive which to be inactive and says E: [TEAC - DV - W5600S] CD Drive No Longer Present
I can't redirect Bath Ripper to the D: drive where the Nimbie is located, and once again the Rip icon in the upper left is not active.
Device manager says the Nimbie is attached and operating fine.
Any thoughts on why I can't seem to direct Bath Ripper to the D: drive and connect to the Nimbie?
I have updated to the new dbPoweramp software and I have made sure the dbPoweramp suite of programs were selected in Windows Security settings under Manage Settings.
I'm pretty puzzled, having spent a couple of hours trying to get this to work again. Any suggestions would be appreciated.
Thanks.
Marc
Comment