Re: Problem ripping with dbPowerAmp 14.3 on Macbook Pro?
yes potentially, if you can try parallels instead of boot camp.
Problem ripping with dbPowerAmp 14.3 on Macbook Pro?
Collapse
X
-
Re: Problem ripping with dbPowerAmp 14.3 on Macbook Pro?
I have since tried Max and XLD as recommended on the Linn forum and both of these ripped successfully with c2 on, so the drive itself must be fine?Leave a comment:
-
Re: Problem ripping with dbPowerAmp 14.3 on Macbook Pro?
C2 is either:
not supported
supported well
supported badly
drive says is supported, but drive is lying about support
Fro yours I think it is supported badly.Leave a comment:
-
Re: Problem ripping with dbPowerAmp 14.3 on Macbook Pro?
Does that not flag up an issue if the detection says it does support it but it actually doesn't?Leave a comment:
-
Re: Problem ripping with dbPowerAmp 14.3 on Macbook Pro?
It is likely the drive does not support it correctlyLeave a comment:
-
Re: Problem ripping with dbPowerAmp 14.3 on Macbook Pro?
Thanks for your help with this. I had looked and posted on the Linn forum about this issue but didn't see anything. Any idea why the c2 detection doesn't work on my mac?Leave a comment:
-
Re: Problem ripping with dbPowerAmp 14.3 on Macbook Pro?
If Accuraterip verifies then the rip is correct.Leave a comment:
-
Re: Problem ripping with dbPowerAmp 14.3 on Macbook Pro?
Thanks. Is this a known common problem?
Should I just go back to using my Windows pc to get a better rip?Leave a comment:
-
Re: Problem ripping with dbPowerAmp 14.3 on Macbook Pro?
It means that c2 is not working correctly on the MACLeave a comment:
-
Re: Problem ripping with dbPowerAmp 14.3 on Macbook Pro?
But I have a test disc that I use to detect that, and it has always worked on my other system?
EDIT: I just tried that and it does rip properly. When I ran the detect C2 errors with my test disc, it said the drive was compatible and enabled it. What is the implications of not using C2 error detection?Last edited by mouldyolddough; November 30, 2012, 11:17 AM.Leave a comment:
-
Re: Problem ripping with dbPowerAmp 14.3 on Macbook Pro?
If you have c2 pointers enabled, try disabling.Leave a comment:
-
Problem ripping with dbPowerAmp 14.3 on Macbook Pro?
I have just installed dbPowerAmp 14.3 on my Win7 bootcamp install on my MBP. It's the new model with i7 2.9Ghz and 8Gb ram. I have tried 3 cds so far and every one gives an error due to needing to rerip about 8000 frames on each track when I have set the limit of reripping 100 frames. I have configured my settings as per the setup document, detected C2 errors etc. Should there be so may frames needing reripped? I have never had this issue on my main Wiindows pc that I used to use to rip.
Is this maybe an issue woth 14.3 as I have just started using this version?
Thanks.Tags: None
Leave a comment: