Multi Encoder Problem

[ikrananka]

I have recently just reinstalled my registered version of dBpoweramp CD Ripper and setup the Multi Enoder utility as before. However, this time I can't set the output location within each encoder to dynamic as I previously could - the dynamic setting is greyed out.

Any suggestions how I can get the dynamic naming within the multi-encoder working again?

BTW - when doing single encoder ripping dynamic naming is available to me.

Thanks for any help

[Spoon]

Dynamic is a Reference feature, look in dBpoweramp Configuraion and make sure it says Reference Registered.

[ikrananka]

I must have had a Reference trial installed at some point because it was working before. Oh well - just upgraded to a registered version of Reference so should be okay now.
Thanks