Dear everyone
I have managed to install Asset onto a Raspberry Pi 4 Version 7.3 mounted in an Argon M.2 case with a 1TB WD Red SATA SSD installed. I can get Asset to work by clicking on the Asset UPNP file in (see below) It can read my music folders stored in Pi/Media/SSD/Lost and Found.
Asset 1.jpg
This brings up the following:
Asset 2.jpg
I tried the setting that was suggested on this forum:
Asset 3.jpg
As yet, I cannot get Asset to run on a reboot.
I am very new to this, so I am sure I have made some very basic mistake.
Any help would be very greatly appreciated.
Kind regards,
David