Problem when ripping: When ripping CDs the rip percent always shows 0% (converting % works okay as does the 0-100% bargraph)?
This issue is on dBpoweramp R17.1 (although it existed on R16.6 as well).
Ripping but always 0%.jpg
Problem when ripping: When ripping CDs the rip percent always shows 0% (converting % works okay as does the 0-100% bargraph)?
This issue is on dBpoweramp R17.1 (although it existed on R16.6 as well).
Ripping but always 0%.jpg
I see that disc was previously ripped, if you rip a new disc it shows the same also?
Spoon
www.dbpoweramp.com
I think I have found the possible cause of this 0% problem?
If DSP setting 'Volume Nomalize' is applied the ripping percent always shows 0% during the ripping process. Once this effect was removed the ripping percent worked correctly again. I tried a few other DSP effects to see if they affected the ripping percent display but they didn't. Hope this helps?
This is because this effect is 'non-live' when the whole track has been ripped the encoding starts, the % shows this.
Spoon
www.dbpoweramp.com
Copyright © illustrate 2024, All rights reserved