Accurate Status Bar dbpoweramp 16.6

[SH Hambrook]

Hi,
Everything else seems to be working but cannot see either progress status slider, initial AccurateRip statement at bottom of track list or track by track AccurateRip status.
Any ideas on how AccurateRip might be recovered?

[Spoon]

If you enable the secure ripping, secure ripping log to 'complete' and 'add to information log (shown after ripping)', do you see this secure result page at the end?

[SH Hambrook]

If you enable the secure ripping, secure ripping log to 'complete' and 'add to information log (shown after ripping)', do you see this secure result page at the end?

Hi, yes secure results page comes up. Accurate rip appears to be working. The problem is that there is no rip progress bar or individual Accurate rip track assessment during ripping.

[Spoon]

You can upload a screenshot please?

[SH Hambrook]

As requested. As I remember, in early runs, Each track had its own rip staus bar and on completion, the AccurateRip verdict was given for each track with a Green tick or a Red cross. In addition, The fact that AccurateRip had found the Album (or) not was displayed at the bottom of track listing.DbPoweramp CD Ripper.jpg

[Spoon]

Yes you are missing the Rip Status column, right click where it says 'Title' and choose 'Default columns'

[SH Hambrook]

Yes you are missing the Rip Status column, right click where it says 'Title' and choose 'Default columns'

Hello, again.

Job done, all back to normal now.

Thank you for your prompt and patiant assistanc.
Regards
SH