How do I reset the PIN code to access configuration settings? I just updated to 6.4 on Qnap and appear to have forgotten the PIN code I had set for the configuration webpage.
How do I reset the PIN code to access configuration settings? I just updated to 6.4 on Qnap and appear to have forgotten the PIN code I had set for the configuration webpage.
The easy way: uninstalling and reinstalling clears all configuration data, including PIN.
The hard way:
SSH into your QNAP - refer to QNAP documentation for details if you have not done this before.
Locate PIN.txt file in Asset settings-
find /share | fgrep PIN.txt
It should print the location of your PIN.txt file, such as:
/share/CE_CACHEDEV3_DATA/.qpkg/Asset/data/.dBpoweramp/uMediaLibrary-v4/PIN.txt
Delete the file:
rm /share/CE_CACHEDEV3_DATA/.qpkg/Asset/data/.dBpoweramp/uMediaLibrary-v4/PIN.txt
Substitute the above /share/... path with the path returned by find.
Last edited by PeterP; 12-12-2019 at 02:49 PM.
I think I‘ll take the easy route! Thanks!
I have run into this same issue but I am on Synology. I want to take the Putty SSH approach as I am failure comfortable in the Linux shell commands. However, I have no idea where the Asset UPnP files are located. Assistance would be appreciated in getting info on the path I need to follow and if I need to delete the same PIN.txt file to clear my previous pin.
Thank you!
See the end of page here:
https://www.dbpoweramp.com/asset-upn...gy-install.htm
Spoon
www.dbpoweramp.com
I would do that if I could get back into config, but since I forgot my Pin I can not do that.
I traced down two different paths where I encountered Asset in the linux shell, however no luck finding the PIN.txt doc
Nevermind, I just dug a little deeper through one of those paths and found what I needed! The info provided for the previous user on the QNAP provided the last bit of info I needed
Copyright © illustrate 2024, All rights reserved