No file produced when file is ripped insecure

[James Lindblom]

Hi!

The dbpoweramp 16.6 [64 bit] doesn't produce any wav-files at all if there is a
problem ripping a track, there should be an incorrect or insecure file produced
but no file at all is produced, this problem file is completely missing. Happens all the time and
have done ever since upgraded to 16.6.

For example this is the log for track 7 of a CD (Cats by Webber):

Track 7: Ripped LBA 94687 to 105767 (2:27) in 5:36. Filename:
Q:\__MUSIC_TEMP\cats\Unknown Artist\07 Unknown Artist - Track 7._
AccurateRip: Inaccurate (confidence 31) Insecure [Pass 1 & 2, Ultra 1
to 6, Re-Rip 108 Frames]
CRC32: 0DD0768C AccurateRip CRC: 3FB94AE7 (CRCv2) [DiscID:
013-0016be6c-00e687e0-a90b4e0d-7]

No file is produced at all.

Here is the settings for this Cats-CD:

Drive & Settings
----------------

Ripping with drive 'E: [ASUS - BW-12D1S-U ]', Drive offset: 667,
Overread Lead-in/out: No
AccurateRip: Active, Using C2: No, Cache: 1024 KB, FUA Cache Invalidate:
No
Pass 1 Drive Speed: Max, Pass 2 Drive Speed: Max
Ultra:: Vary Drive Speed: No, Min Passes: 3, Max Passes: 6, Finish After
Clean Passes: 2
Bad Sector Re-rip:: Drive Speed: Max, Maximum Re-reads: 34

Encoder: Wave -compression="PCM"
DSP Effects / Actions: -dspeffect1="HDCD= -6DBAmp"

James

[Spoon]

In secure settings make sure that these are NOT set:

'Mark Track as Error if Insecure'

Secure Rip section - all set to (no abort)