If I make a Batch convert to removable drive G: and thn remove the media from G:, when I then attempt a Batch convert to another drive I get:
UpS0njG.png
Definitely the second operation is not referencing G:
C5M5dn3.png
Bug?
If I make a Batch convert to removable drive G: and thn remove the media from G:, when I then attempt a Batch convert to another drive I get:
UpS0njG.png
Definitely the second operation is not referencing G:
C5M5dn3.png
Bug?
Possible bug noted.
Spoon
www.dbpoweramp.com
Are you certain there were no dsp effects, such as a xml writer?
I inserted a removable disk, loaded batch converter, selected 1 file >> convert >> set output location to removable disk, did conversion, then removed disk. Restarted batch converter, selected the same file >> convert >> changed the location to 'same as source' and clicked convert, no msg about insert disk was shown, this is on Windows 10.
Spoon
www.dbpoweramp.com
Here are the DSP effects in use: https://i.imgur.com/P4Xdu4B.png
This is on Windows 7.
Can you run my test with a single file, does it show the msg? with and without dsp effects.
Spoon
www.dbpoweramp.com
Copyright © illustrate 2024, All rights reserved