This Asset build is for Debian, but it will also run on other Linux versions
Installation details
To install it is done through the SSH command-line, for headless devices, install 'Putty' then connect to the device to access command-shell.
Code:
Create a folder for Asset:
cd /usr/bin
sudo mkdir asset
sudo chmod 777 asset
cd asset
Download asset (32 bit) on your PC and transfer to your linux device, then unzip:
extract it:
tar -zxvf *.gz
rm *.gz
Run Asset:
cd /usr/bin/asset/Asset-R6-Linux-x64-registered/bin
./AssetUPnP
Once running it will show Presentation URL type this into a web browser on any computer on the same network, example:
http://192.168.1.13:45537
Then click 'configure' to specify the options
Setting Asset to start automatically
Code:
sudo crontab -e
press the down arrow until the cursor is right at the bottom (on a blank line, press enter if not on a blank line)
type:
@reboot /usr/bin/asset/Asset-R6-Linux-x64-registered/bin/AssetUPnP
Press keys CTRL + X choose Y to save, press enter
restart system:
sudo reboot
The web log-in will be the same as when run manually, if at a later date you cannot find this address (or port), log into the pi and type:
ifconfig
this will show on the inet addr for eth0, take the shown ip address and:
http://x.x.x.x:45537
Where x.x.x.x is the address shown
To find the port asset is using:
sudo netstat -pln
look for the lines with AssetUPnP on the end, it should be shown as 0.0.0.0.0:45537 (for configuration) (as well as 0.0.0.0.0:26125 which is used by UPnP devices and 0.0.0.0.0:1900 for broadcast)
The configuration files for Asset are stored: ~/.dBpoweramp