-
Ripping Machine Config
I’ve finally got around to specing out my new ripping tower
And before I start ordering parts and building I seek the collective wisdom
of the forum. I plan to run 8 drives using Batch Ripper but am
prepared to drop down to six if need be.
The plan is to rip to outboard USB 3 drives
Mostly MP3 but possibly to Flac also
if I can do it simultaneously.
So gents, what do you think of this system?
Will it work as I invision?
All suggestions and insight are most welcome
Thanx to all in advance
Coolmaster Storm Trooper ATX Case
Intel I7-377OK CPU
Asus P8277-V Pro 1155 ATX Motherboard
Samsung E 256GB SSD 840 Pro2.5 Sata3 (Boot Drive)
Antec HCG 900W ATX Power Supply
Crucial 16GB 8x2 D3 1600 DIMM C9 (RAM)
Seagate 2TB 3.5 7200RPM Int Sata
WINDOEWS 7 64Bit SP1 OEM
SYBA 2Prt Sata LO-Pro PCIE-1X (Controller)
8 CD Drives (Still Researching what’s available and open to reccomendations)
-
Re: Ripping Machine Config
HI, heres my twopenneths worth, it may be advisable to check whether you can run just four cd drives with your proposed set up as the CPU has four cores and four threads, making theoretical eight core unit , you will need two cores for each cd drive, one to process the data off the disc,another one to process the data to what ever format you decide upon, ie mp3 or FLAC. Also make sure that you have a descent anti virus programme installed as I found alot of malicious stuff when looking for album art etc. I hope that this helps.
-
Re: Ripping Machine Config
What throughput are you looking to achieve? How will you be loading the drives? I achieved 72 discs per hour on a 4 drive on an HP Proliant ML115 with a pretty slow quad core amd processor and only 2GB of RAM by hand. This was ripping to FLAC, don't waste time with mp3. It was a full time job taking CDs out of cases, cleaning them and then putting them back. I doubt you could service more than 6 drives by hand. As it happens sometimes all CDs finish very close to each other and you end up with down time anyway.
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Copyright © illustrate 2024, All rights reserved