I see something in the secure section, but secure slows ripping down to a crawl.
Any way to have Batch Ripper re-rip an inaccurate track n number of times before giving up?
Arlo
I see something in the secure section, but secure slows ripping down to a crawl.
Any way to have Batch Ripper re-rip an inaccurate track n number of times before giving up?
Arlo
Rather than re-rip an inaccurate track, you should set options to re-rip inaccurate frames, there is no need to re-rip any other area of the disc if ripped correctly.
Spoon
www.dbpoweramp.com
Where is that set?
On profile page >> options >> secure settings >>
Lots of options
Gotcha... I know about these settings, they're the ones that significantly increase the time it takes to rip a CD.
I thought this was a simple setting to apply during a batch rip.
Batch Ripper has full access to CD Rippers options via the Profile button.
Spoon
www.dbpoweramp.com
That's because it actually takes so much time to re-rip individual frames. Wouldn't go quicker to re-rip the entire track.
When I did rip through my changer, I would set it to abort after only a few re-reads, and rather try my luck in another drive. It does not even have to be a "better" drive, just a different drive. And then I could leave it overnight there, rather than wearing the changer (which would be a much more expensive piece of equipment to replace).
Copyright © illustrate 2024, All rights reserved