Can't save to Buffalo Linkstation

[rasowe]

Hi everyone,

I'm a dbpoweramp newbie and I'm setting things up so that I can rip on two separate machines - a desktop and my laptop. To do this I purchased 4TB Buffalo Linkstation NAS server that I installed to my network with no apparent problems. The NAS shows up in windows explorer and on the network map.

However, when I try to select the rip destination on the laptop I can't find the NAS, even though it shows up on the desktop. The software is configured identically on both machines.

The NAS is connected to the router via an ethernet cable but both laptop and desktop are connected wirelessly.

I've tried all the obvious things like rebooting both machines, I also reinstalled the software but it made no difference.

Any suggestions would be appreciated as I'm struggling for a solution.

Many thanks

[Spoon]

Right click on the network share and select 'Map Network Drive...'

Then you can select an actual drive letter.

[rasowe]

Right click on the network share and select 'Map Network Drive...'

Then you can select an actual drive letter.

I tried mapping my folder but when try to find it from the "browse for folder" window it's just not in the network.

[Spoon]

You map the network share to say drive letter M:

then you browse and select M:, from your computer, not from the network.

[rasowe]

You map the network share to say drive letter M:

then you browse and select M:, from your computer, not from the network.

Ok, I've got it :smile:.

Many thanks for your help.