CDGrab won't

[ephoras]

Registered and installed R12 last weekend on a newly created W2K Pro SP4 system and then tried to Rip some CD's to mp3 - it reckons all the CD's I put in are errored, but they play using Windows Media.
I was going to buy the CD Writer as well but don't feel inclined if the Ripper does not work.
Is it the setup or is there a problem with CDGrab?


CD/DVD Details
Manufacturer: LITE-ON
CD Drive: COMBO SOHC-5232K
Firmware: NK02
Serial: Nov07 ,2003
Maximum Speed: 9173 KB/sec (x52)
Current Speed: 9173 KB/sec (x52)
Spin-down After: 4 minutes
Buffer Size: 2 MB
Accurate Stream: Yes
C2 Error Pointers: Yes
Reads ISRC: Yes
Reads UPC: Yes

[LtData]

Are you running dMC as an administrator? When you say "errored" do you mean the conversion gives you errors, or the CDs are inaccurate/insecure?

[ephoras]

I am in administrator mode

The exact error for every track of every CD is
Error ripping to mp3 (Lame) file name
Unable to read CD, check CD disk frame LBA nnnnn

[LtData]

What CD Communication set are you using, SCSI Pass-Through or Windows Limited?

[Spoon]

Try windows limited.

[ephoras]

Thanks for the suggestions but they went around a mile over my head