Search:

To both also, Mike you see a high CPU usage?

The cpu would be used when scanning the tracks, we would not expect any cpu usage when the NAS is not indexing, unless something is hammering the...

It is the program which decides which to display (album artist or artist), asset just presents both as required by UPNP standard. Other apps do not present Album artist at all.

How many tracks do you both have?

Run Batch Ripper, next to the profile box at the top click 'Edit' and CD Ripper appears to edit the settings.

Unless the files are removed then added again later, they should not be re-listened to. The files will be listed though.

It is better to use the DSP effect Resample to 48KHz because our resampler is better than the one in lame (if the source was not already 48KHz, if always 48KHz then no need).

Select the Wave encoder, choose Compressed >> Settings

On my Windows 10 it lists CCITT U-Law

any codecs on that page are provided by Windows, not dBpoweramp, they are system encoders.

If the files have changed, because of tagging change, or any file changes (look at last write for the file), they will be rescanned.

Try restarting Windows in Safe-Mode with Networking, then try CD Ripper R17.3, does it work?

Security software, restart your Windows in Safemode, this ensures nothing else is running, then install.

Linux is not as good as Windows to detect file changes, for this reason you are best setting it to rescan every 10 minutes.

We looked at it and there was no method to submit through a ripping application, from what we could see.

Which exact version of dBpoweramp do you have?

You would use a control point, so the Naim app which runs on ipads, etc, to control playback.

It is not possible to launch music converter this way.

>48k/112kbps

You need to go on the advanced page for mp3 (Lame) and choose 48KHz for the frequency. At this low bit rate without 48khz forced, even if the source is 48khz, lame will convert to...

/Volumes/music/iTunes 2/iTunes Media/Music/

This looks like a path on your MAC, you would need the correct path on the Synology

If it is a one off conversion of WMA, keep with dBP on the mac, and install the trial version on Windows which will allow the conversion from WMA to FLAC.

The drive is not able to read the CD. A new drive is needed or a new CD.

Yes, the naming box on the main page is, however on the settings page for each encoder within multi-encoder is a naming box specific to that encoder.

You need to set the naming string and output to location on each encoder page.

If you choose flac as the encoder (instead of multi encoder) on the main CD Ripper and copy the naming string onto...

When ripping the whole CD is there for AccurateRip to work even on single tracks. If you have already ripped 1 file and do not have the AccurateRip disc ID in the tags, it cannot be looked up.

ALAC has no uncompressed option, it is always compressed, similar to FLAC at level 5.

Good find, the SPT is the default mode unless CD Ripper cannot access the drive, so it chooses the internal, it must have been that to begin with.

If the dialog only says maximum it is unlikely the drive will accept any speed alteration. The request for drive speeds and setting of drive speed is hardware dependent, a different controller can...