PDA

View Full Version : dynamic greyed out!!



jon40084
07-02-2014, 02:03 PM
Hi,
I'm sure I'm going mad but dynamic is greyed out when I attempt to convert to mp3. I'm sure I can't be the only one but can't see anything in the forums that might resolve it.

Cheers

Spoon
07-02-2014, 04:28 PM
It will be because dBpoweramp Reference is required, if you run dBpoweramp Configuration it will show the registration status.

jon40084
07-03-2014, 07:02 AM
Hi Spoon - I have version 15.1 registered version.

garym
07-03-2014, 07:31 AM
Hi Spoon - I have version 15.1 registered version.

have you installed the LAME (mp3) codec?

Spoon
07-03-2014, 09:05 AM
mp3 (Lame) encoder comes with all version of dBpoweramp.

The configuration page should show as this image indicates:

http://www.dbpoweramp.com/misc/dbp-config.png

jon40084
07-03-2014, 01:28 PM
It's definately showing as registered

267

Spoon
07-03-2014, 01:37 PM
The Power Pack does not enable Dynamic, dBpoweramp Reference is required, which is a different version.

Beeman
07-06-2014, 09:45 PM
Same problem here. Purchased the software in 2009 never had this problem. Updated to 13.5 "registered" and dynamic is ghosted. Now have Reference 15.1 and dynamic output is still ghosted/ unavailable.

dbfan
07-07-2014, 05:01 AM
If your encoder is set to multi encoder then dynamic is on the encoder settings page, the one on the main page is not used. Also check your configuration program looks exactly like the one above.

BrodyBoy
07-07-2014, 04:48 PM
If your encoder is set to multi encoder then dynamic is on the encoder settings page, the one on the main page is not used. Also check your configuration program looks exactly like the one above.

Ditto! :)

Whenever I've seen this issue come up, it seem the poster was using multi-encoder.