PDA

View Full Version : Cd Writer Writing


Cory444444
11-02-2003, 02:18 PM
When I try to burn a CD, the writer always gets to 89% then says "Writing has occured but recovery is needed." What does it mean?
Spoon
11-02-2003, 03:48 PM
Not sure, I haven't seen this before - what type of CD are you writing? audio cd or mp3?
Cory444444
11-03-2003, 09:09 PM
Audio.
Spoon
11-04-2003, 04:09 PM
That percentage value corresponds as though you are writing 80 minutes to a 74 minute CD. Just a guess though?
Cory444444
11-06-2003, 08:17 PM
No, I'm writing about 78 minutes onto a 80 min CD.
Razgo
11-06-2003, 11:20 PM
because of the nature of the error message, can it be something that your actual cd burner is reporting? what is your cd burner?
Cory444444
11-07-2003, 07:16 PM
Plextor
Spoon
11-09-2003, 07:01 AM
Just out of interest try creating an audio CD that is less than 74 minutes long.
Cory444444
11-10-2003, 02:49 PM
Well I made a CD that's 50 min. and the warning message didn't pop up or anything, the CD was completely written. So I gues I should write CDs that don't have so many songs on them, right?
Spoon
11-10-2003, 07:08 PM
It is possibly length, rather than track count - I think if you stay below 70 minutes you will be fine, although I cannot guess what is causing this on your setup.
Cory444444
11-11-2003, 07:21 PM
Thanx.
zevele1
12-15-2003, 07:05 PM
Thanx.

Part of the cd is used to put infos concerning the burn.

So ,if you are to close to the total MB you can burn , you may get this kind of problem.

Well ,it is the case when you burn an data cd
Can be the same burning a RedBook one