View Full Version : Secure Ripping fails
scoughlan
07-03-2011, 01:06 PM
I'm using Win7 64-bit and a Samsung SH-S223C drive. It rips fine in Burst mode but crawls in Secure mode and eventually fails. I tried deleting the upper and lower filters in the registry with no effect, and I've updated the firmware to the latest SB06 version. If I look at the IDE controllers in Device Manager on the Advanced Settings tab to check for DMA mode, they are just blank: Nothing at all like the screen shots I have seen on the web.
Any help greatly appreciated.
Simon
Spoon
07-03-2011, 01:48 PM
Disable c2 pointers if you have them enabled.
scoughlan
07-03-2011, 03:50 PM
Thanks for the advice Spoon, but it wasn't the C2 pointers. I finally solved my own problem after many hours...:yawn:
I'm using AHCI but my Asus M4A88TD-M EVO motherboard allows the user to subdivide the SATA ports to assign different modes. Once I'd done this, and moved the cable to the respective SATA port, I was able to assign the DVD back to IDE and UDMA5, and all works well now.
Thanks again, S
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.