PDA

View Full Version : iTunes control?



KJim
08-16-2007, 06:15 AM
Hallo all,

Bit of an odd one. For reasons way too boring to list here, I need to encode MPEG-2 AAC low-complexity ADTS and MPEG-4 (Quicktime) AAC low-complexity ADTS, and I need to do it using the dreaded iTunes. Is there a way to use iTunes to encode from a DMC front? I've tried using CLI, but don't really know where to point it... I tried pointing it at the iTunes.exe file, but it just started iTunes and created a zero length file. Any ideas?

Just to pre-empt the "don't use iTunes for this" comments- as I said, for reasons too boring to list here, it has to be iTunes!

Any and all ideas gratefully appreciated!

LtData
08-16-2007, 07:08 AM
There used to be a codec that would start up iTunes and encode, but it is long replaced by the Nero Digital codec. Currently, there is no way to use dMC to have iTunes encode to specific settings.

KJim
08-16-2007, 07:16 AM
Any chance of getting hold of a copy of that old codec? I realise it may be obsolete, but it may be my only hope! Even if I have to get hold of a legacy version of DMC to run it...

LtData
08-16-2007, 07:27 AM
I don't have a copy of it, but you are right in that it would require an old version of dMC to run, dMC r11.5. Spoon could possibly have it, but one thing I remembered is that the codec quit working after an iTunes update, I believe to 6.x, so it may not even work now.

KJim
08-16-2007, 07:56 AM
Ok thanks very much- it was a long shot...